CH
EN
| Serial Number | Prject | Detail |
| 1 | Theory |
PL (photoluminescence technology) equipment using a customized laser to project to the surface of the battery the battery will produce fluorescence through the high-sensitive infrared camera to obtain the image of the battery the use of AI image recognition algorithm you can detect defects and then realize the alarm eliminate and other functions to improve the quality of the production line |
| 2 | NG cutting mode |
★According to the onsite hardware environment the buyer and the seller shall confirm and select one of the following methods before signing the agreement: (The blanking module is optional not provided by default) 1. Giant can provide blanking module 2. Communication with automation by automation of the material |
| 3 | Shooting darkroom dimensions（mm） |
★Estimated size buyer and seller confirm the demand give the final size L、W、H: 332X510X885(Estimated size no calculated cut) |
| 4 | Minimum station size required（mm） |
★The module needs to be installed on the automation equipment so it needs to be adapted to the automation and the buyer and seller will give the final size after confirming the demand： A.Darkroom installation space requirements； B.Cutting hand installation space requirements； C.Photo position cutting position the distance between the two needs; (Reserve algorithm processing time) |
| 5 | Communication mode |
★The buyer and seller shall confirm the agreement before signing according to the onsite hardware environment. The buyer should confirm the following information in advance and select the corresponding hardware configuration：（★Default network port communication） A.Communication mode such as IO or network port； B.Communication protocol。 |
| 6 | Weight（kg） | 20 |
| 7 | Voltage(v） | 220 |
| 8 | Power(kw) | 1 |
| 9 | Air source requirement(MPa) | 0.5-0.7 |
| 10 | Sets in use | ＞99% |
| 11 | Fragmentation rate | ＜0.005%(Class A film source) |
| 12 | Capacity(WPH) | ＞5000 |
| 13 | Compatible with battery size | ★Hardware customization（Default support 156~230mm） |
| 14 | Compatible with battery type | Supporting single crystal |
| 15 | Work environment | Temperature：﹢15℃～﹢40℃; Humidity：10％～75％ |
| 16 | Check the process status of the battery |
1.Conditions must be met: After the coating is completed the battery is facing up on the flow line that has been coated and the PL camera shoots from top to bottom. 2.Best conditions: the two-sided coating of the battery is completed the battery is facing upward on the flow line and the coating surface of the battery is shot from the top down. |
CH